GM 3.5L V6 Index of Articles
How To Test The MAP Sensor (2007-2008 3.5L Malibu)
- August 10, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

Testing the MAP sensor on the 2007 and 2008 3.5L Chevy Malibu is a piece of cake, especially because the MAP sensor sits right on top of the intake manifold and is easy to get to. In this tutorial I'll explain how to test it using a multimeter... read more >>
Throttle Body (TAC) Circuit Wiring Diagram (2004-2006 3.5L Malibu)
- July 28, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

The Thottle Actuator Control (TAC) Module is the electronic throttle body on the 2004, 2005, and 2006 3.5L Chevrolet Malibu. This bad boy is located on the intake manifold plenum (the photo above is of the TAC Module). NOTE: The following... read more >>
How To Do A Cylinder Balance Test (2004-2008 3.5L Malibu)
- July 23, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

This tutorial will explain how to do a manual cylinder balance test on the 2004, 2005, 2006, 2007, and 2008 3.5L V6 Chevrolet Malibu. The cool thing is that you don't need any expensive or exotic test equipment to do a manual cylinder balance... read more >>
Fuel Pump Wiring Diagram (2004-2005 3.5L Malibu)
- July 28, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

Here's a simplified fuel pump wiring diagram. The above typical fuel pump circuit wiring diagrams applies only to the 2004 and 2005 3.5L V6 Chevrolet Malibu. NOTE: You can find the fuel pump test for the 2004-2008 3.5L Chevrolet Malibu here:... read more >>
How To Test The MAP Sensor (2004-2006 3.5L Malibu)
- July 20, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

Testing the MAP sensor is not difficult on the 2004, 2005, and 2006 3.5L V6 Chevy Malibu. The cool thing is that it can be accurately tested using only a multimeter and a vacuum pump. In this tutorial I'll explain how to test it and with the... read more >>
Ignition System Wiring Diagram (2004-2005 3.5L Malibu)
- July 27, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

The above ignition system wiring diagrams apply only to the 2004 and 2005 3.5L V6 Chevrolet Malibu. NOTE: The ignition control module (ICM) is part of the coil pack assembly. Ignition Control Module Connector Pin... read more >>
How Often Should I Replace The Spark Plugs (2004-2008 3.5L Malibu)
- July 18, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

The spark plugs are probably one of the most inexpensive components installed on your 2004, 2005, 2006, 2007, or 2008 Chevy Malibu 3.5L engine. And yet they perform a supercritical job. Sooner or later they're going to have to be replaced. And... read more >>
How To Test The Fuel Injectors (2004-2006 3.5L Malibu)
- July 26, 2018
- Updated: July 17, 2020
- Written by: Abraham Torres-Arredondo

Testing the fuel injectors of the 2004, 2005, and 2006 3.5L V6 Chevy Malibu can seem quite impossible, since they're located underneath the intake manifold plenum. But nothing could be further from the truth because you don't have to remove the... read more >>
How To Test A Blown Head Gasket (2004-2010 3.5L V6 GM Engine)
- July 18, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

This tutorial will help you to test for a blown head gasket on the 3.5L V6 equipped GM vehicles. These are the: 2006-2010 Chevrolet Impala, 2005-2009 Chevrolet Malibu, 2005-2006 Chevrolet Uplander, 2005-2010 Pontiac G6, 2005-2006 Pontiac... read more >>
How To Test The MAF Sensor (2004-2008 3.5L Malibu)
- July 23, 2018
- Updated: June 04, 2020
- Written by: Abraham Torres-Arredondo

The mass airflow (MAF) sensor on the 2004, 2005, 2006, 2007, and 2008 3.5L Chevrolet Malibu, can be tested using only a multimeter (that can read Hertz frequency). With the results of your test you'll be able to conclude if the mass airflow... read more >>